AmpliVox S206A Operating Instructions

S206A Belt Blaster Personal Waistband Amplifier
INCLUDED:
Belt Blaster Personal Waistband Amplifier; 44" Adjustable Belt, 12" Belt
Extender, Carrying Case, Headset and Lapel Microphones
OPERATING INSTRUCTIONS
1. Open the battery cabinet cover of the amplifier and insert 6 AA
batteries (1.5V), Close the cabinet cover.
2. Put the amplifier on your waist, adjust the attached belt to fit, then clip the buckle.
3. Insert the *screw-on jack of the microphone into the socket on the amplifier and turn
the plug the collar clockwise onto the socket to secure the connection, then position
your microphone adequately.
*The screw-on jack prohibits the cable from inadvertently pulling out when moving around.
4. Rotate the ON/OFF switch clockwise, turn the volume up until the whistle can just be
avoided. Now you are ready to use the Belt Blaster.
S207A Belt Blaster PRO Personal Waistband Amplifier
INCLUDED:
1. Belt Blaster Pro Personal Waistband Amplifier
2. 44" Adjustable Belt
3. 12" Belt Extender (not shown)
4. Headset Mic
5. Lapel mic
6. AC Adapter/Recharger
7. Carrying Case
8. Acoustic Neoprene Case
9. 6 NiMH rechargeable batteries

INSERTING/CHANGING THE BATTERIES

About Nickel Metal-Hydride Batteries

The NiMH batteries of your new Belt Blaster Pro will have a life expectancy of approximately
2 years. Actual life will vary significantly depending on your usage and charging habits. There
may be a time when you need to use back-up power to get through a presentation. The Belt
Blaster Pro was intentionally designed to accommodate standard AA battery cells for just
such occasions.
In the event you need to change the batteries of your Belt Blaster Pro, either for temporary
use with disposable AA batteries or to install a new set of NiMH cells, follow these steps:
Remove existing batteries:
1. Locate the battery compartment on the right rear side of the amplifier.
2. Press (do not pry) the cover locking tab to the right and lift to remove battery cover.
3. Gently lift the red battery ribbon to loosen and remove all of the batteries.
Installing batteries:
1. Lace the red battery ribbon across the bottom of the batteries.
2. Install the 2 cells on the bottom row with negative contact (-) toward spring.
3. Install the 4 cells on the top row with battery positive contact (-) toward springs.
4. Insert anchor tabs of battery cover into case.
5. Lower cover down into case and press locking tab to left to latch cover.
PHONE (800) 267-5486
1, 2
FAX: (800) 267-5489
WAISTBAND AMPLIFIER
4
6
WEB: WWW.AMPLI.COM
Wireless Portable Public Address
S206A/S207A
5
7
8
9
Press In &
Lift Open
EMAIL: INFO@AMPLI.COM