Worksurface Safety; Installation Requirements; Tools And Parts; Location Requirements - Amana LAUNDRY WORKSURFACE Use And Care Manual

WORKSURFACE SAFETY

INSTALLATION REqUIREMENTS

TOOLS AND PARTS

Gather the required tools and parts before starting installation.
Tools needed:
Tape measure

LOCATION REqUIREMENTS

The worksurface can be installed on top of a front-loading washer
and dryer pair situated next to each other. The washer and dryer
must be level side to side and front to back and at the same
height. Proper installation is your responsibility.
Installation Spacing:
The worksurface will fit on top of a washer and dryer that are
each 27" (686 mm) wide and have a spacing of approximately
1" (25 mm) between them for the alignment pads.
2
Level
Worksurface dimensions:
Top view:
Bottom view:
NOTE: The worksurface will add 3" (76 mm) to the overall height
of your washer and dryer.