Table of Contents
Advertisement
10. Line out selector (two 2-pin LO_L, LO_R) (on audio models only)
By default, these jumpers are shorted (jumper caps on) to route the
signal from the audio controller to the rear panel Line Out jack, making
the jack available for audio out devices such as speakers or a
headphone. If you connect the Intel Front Panel audio cable to the
AAPANEL connector (see page 2-33 for the location), remove the caps
from these jumpers to allow automatic switching of audio signal
between the rear panel Line Out jack and the Intel audio cable.
®
P4B266-E
P4B266-E Internal Line Out Connectors
11. Bass/Center setting (3-pin BCS1, BCS2) (on audio models only)
These jumpers allow you to select the speaker output for a 6-channel
audio system. No audio standard exists for the three pick-up surfaces
on male audio ports, so it is necessary to switch the jumpers from the
default position CENTER/BASS (pins 2-3) to BASS/CENTER (pins
1-2) to re-route signals on the internal leads of the Mic port.
Install the audio driver included in the support CD to use the multi-
channel audio feature. See section "5.3 Software information."
®
P4B266-E
P4B266-E Bass Center Setting
ASUS P4B266-E motherboard user guide
LO_L
LO_R
BCS
1 2
BCS2
BCS2
BCS1
BCS1
(BASS/CENTER)
(CENTER/BASS)
2 3
(Default)
2-23
Advertisement
Table of Contents
