Table of Contents
Advertisement
The Remote Control for Cable Box Functions
Operating the precoded function for your cable
box.
This remote is designed to operate different types of
cable boxes. You must first program the remote to
match the remote system of your cable box (refer to
pages 41-42 for pre-codes).
1. Turn ON your cable box.
2. Aim the remote control at the front of your cable
box.
3. To switch to Cable (CBL) pre-coded mode, use the
SOURCE ACCESS buttons (
control to position the LED light to the
corresponding selection.
4. Hold down the ENT button on the remote and enter
the four digit preset code that matches your cable
box as shown on pages 41-42. Release the ENT
button. The indicator light will flash 3 times if the
code was accepted.
5. Aim the remote at the cable box and press the
POWER button. The remote will turn off your cable
box when the correct four digit preset code is
entered. When this occurs, the remote control is
programmed for your cable box. If the cable box
does not turn off, try a different four digit preset
code.
6. The remote will now control your Cable box.
NOTE: 1. If your cable box cannot be operated after
performing the above procedures, your
cable box code has not been precoded
into the remote.
2. In the unlikely event that your cable box
cannot be operated after performing the
above procedures, please consult your
cable box operating guide.
3. The remote control will remember the
codes you have programmed until the
batteries are removed from the from the
remote control. After replacing the
batteries repeat the entire programming
procedure as stated above.
PRECODED CABLE BOX buttons
These buttons transmit the chosen precoded cable
codes.
EXCLUSIVE TV buttons
These buttons are for operating the TV.
or
) on the remote
MY CABLE BOX CODE IS:
NOTE: Refer to instruction manual of the Cable Box
/
for operation of the buttons exclusively for
the Cable Box.
35
Hide quick links:
Advertisement
Table of Contents
