Fiery 750DP - Phaser Color Laser Printer Administration Manual page 76

3
3-16 Setting up network servers
T
O INSTALL UTILITIES ON OTHER CLIENT WORKSTATIONS
1. Make sure your configuration file works on one computer before you install the utili-
ties on other workstations. Start one of the utilities on the original host computer and
connect to the Fiery SI you configured.
In order for the connection to take place:
The Server name entry in the NET_WSCK.INI file must be the same as the server
name you gave the Fiery SI in the Control Panel Server Setup.
The device name entry in the NET_WSCK.INI file must match the device name that
is internal to the Fiery SI.
2. Make sure that the IPX/SPX-compatible Protocol has been loaded on each workstation.
Also install Microsoft TCP/IP.
3. Install the utilities.
See Getting Started for details.
4. When you see the prompt to find the NET_WSCK.INI file, insert the floppy disk you pre-
pared.
The edited file is copied to the active Windows folder on the user's workstation. This
method ensures that all users on the network have the correctly edited file.
5. Before you run the utilities on a client workstation, make sure that it is using the
same Ethernet frame type as the setting on the Fiery SI.
You set the frame type on the Fiery SI in IPX (Novell) Setup in Ethernet Setup; the
current setting is listed on the Fiery SI configuration page. Getting Started tells you
how to check the frame type setting on the Windows 95 workstation.
: