Chassis Footpads And Roller Wheels - Asus AP130-E1 User Manual

Intel pentium 4 5u rackmount server 800/533mhz front side bus

Hide thumbs Also See for AP130-E1:

Table of Contents

2.10.7 Chassis footpads and roller wheels

The barebone server system is shipped with four footpads attached to the

bottom of the chassis for stability. You need to remove these footpads if:

•

if you want to replace the footpads with the bundled roller wheels

•

you wish to install the system to a rack

(Refer to "Chapter 3 Installation options" of this user guide, and to the

"Rackmount Kit" user guide for instructions)

To remove the footpads:

1. Lay the system chassis on its

side.

2. Use a flat screwdriver to flip out

the top layer of a footpad.

3. Remove the footpad by rotating it

counterclockwise.

4. Repeat steps 2 and 3 to remove the other three footpads.

ASUS AP1720-E1 barebone server

2-43

Table of Contents