Download Print this page
ARC Audio FD1200.1 Owner's Manual

ARC Audio FD1200.1 Owner's Manual

Monoblock high performance audio amplifier

Advertisement

Quick Links

FD600.1
FD1200.1

Advertisement

loading
Need help?

Need help?

Do you have a question about the FD1200.1 and is the answer not in the manual?

Questions and answers

Summary of Contents for ARC Audio FD1200.1

  • Page 1 FD600.1 FD1200.1...
  • Page 2 Setting the Gains So you're worried that your 4 Volt output head unit will be too much for the ARC Audio's 2.5 Volt If you do not have experience with automotive electrical and mechanical systems contact input stage.
  • Page 3: Speaker Outputs

    Input Section Bass Boost Because of the wide range of head unit output configurations all ARC This amp has a fully adjustable bass boost. Both the frequency and the Audio amplifiers have an adjustable input sensitivity or “Gain” . The gain level of the boost are adjustable.
  • Page 4 Bridging Bridging Cont. Bridging is a way to combine the power of 2 channels into 1. When For bridging to work both amplifiers must be playing exactly the same you wire the amp bridged you have a higher voltage differential signal at exactly the same output level.
  • Page 5 Installation Instructions Connect the speaker wire to the amp and speakers (make sure Disconnect the negative cable from the car battery. Tape up the end the amp is off first). Make sure the polarity (+ and-) is correct. so it is isolated form the battery. Connect the RCA’s to the amp.
  • Page 6 2 OHM OPERATION 1 OHM OPERATION SET PHASE TO SET LOAD TO SET INUT TO SET PHASE TO SET LOAD TO SET INUT TO <IN TWO> NORMAL> <IN <ONE NORMAL> 2 0HMS 1 0HMS _ 10D2 = 2 _ 10D4 = 2 _ 10D2 = 1 _ 10D2 = 1 12D2 = 2...
  • Page 7 4 OHMS BRIDGED In this configuration you can “Bridge” 2 amplifiers into 1 channel. To bridge 2 amps you must set amp 1 to “Normal” and amp 2 to “Slave” . All adjustments will then be made to amp 1. Amp 2 will need no further adjustments SET PHASE TO SET LOAD TO...
  • Page 8 2 OHMS BRIDGED In this configuration you can “Bridge” 2 amplifiers into 1 channel. To bridge 2 amps you must set amp 1 to “Normal” and amp 2 to “Slave” . All adjustments will then be made to amp 1. Amp 2 will need no further adjustments SET PHASE TO SET LOAD TO...
  • Page 9: Power And Input Connections

    POWER AND INPUT CONNECTIONS POWER AND INPUT CONNECTIONS DUAL BATTERY or BATTERY AND CAPACITOR SINGLE BATTERY FUSE FUSE REMOTE REMOTE Battery or Capacitor FUSE Battery This is a stock ground wire on the This is a stock ground wire on the battery between the battery and battery between the battery and Battery...
  • Page 10: Specifications

    Specifications FD600.1 FD1200.1 1 Channels @ 4Ohms 336 Watts 510 Watts 1 Channels @ 2Ohms 620 Watts 1010 Watts 1 Channels @ 1Ohm 600 Watts 1100 Watts 20 Hz > 250Hz 20 Hz > 250Hz Frequency Response Crossover Range 30Hz - 250Hz 55Hz - 250Hz Bass Boost...

This manual is also suitable for:

Fd600.1