Table of Contents

Advertisement

Available languages

Available languages

IMPORTANT INSTRUCTIONS -
Models: ESSEV28, ESSEV30
READ AND SAVE THESE INSTRUCTIONS
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED.
PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH
INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE!

GENERAL SAFETY INFORMATION

electric shock and injury to person, including the following:
WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK
AND INJURY TO PERSON, OBSERVE THE FOLLOWING:
a) Use this unit only in the manner intended by the manufacturer.If you
have questions, contact the manufacturer.
b) Before servicing or cleaning the unit, switch power off at service
panel and lock the service disconnecting means to prevent power
from being switched on accidentally. When the service discon-
necting means cannot be locked, securely fasten a prominent
warning device, such as a tag, to the service panel.
WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK
AND INJURY TO PERSON, OBSERVE THE FOLLOWING:
a) Installation work and electrical wiring must be done by qualified
person(s) in accordance with all applicable codes and standards,
including fire-related construction.
b) Sufficient air is needed for proper combustion and exhausting
of gases through the flue (chimney) of fuel burning equipment to
prevent back drafting. Follow the heating equipment manufacturer's
guideline and safety standards such as those published by the
National Fire Protection Association (NFPA) and the American
Society for Heating, Refrigeration, and Air Conditioning Engineers
(ASHRAE), and the local code authorities.
c) When cutting or drilling into wall or ceiling, do not damage electrical
wiring and other hidden utilities.
CAUTION:
TO REDUCE THE RISK OF FIRE AND TO PROPERLY
EXHAUST AIR, BE SURE TO DUCT AIR OUTSIDE - DO NOT VENT
EXHAUST AIR INTO SPACES WITHIN WALLS OR CEILINGS OR INTO
ATTICS, CRAWL SPACES, OR GARAGES.
d) Ducted fans must always be vented to the outdoors.
e) This unit must be grounded.
f) To avoid motor bearing damage and noisy and/or unbalanced
impellers, keep drywall spray, construction dust, etc. off power unit.
g) Read all instructions before installing or using exhaust fan.
6728028 Rev. A 7-10
OPERATING MANUAL
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
When using electrical appliances, basic precautions
should always be followed to reduce the risk of fire,
SAVE THESE INSTRUCTIONS
WARNING:
NOT USE THIS FAN WITH ANY SOLID-STATE SPEED CONTROL DEVICE.
WARNING:
a) Never leave surface units unattended at high settings.
Boilovers cause smoking and greasy spillovers that may
ignite. Heat oils slowly on low or medium settings.
b) Always turn hood ON when cooking at high heat or when
flambéing food (ie. Crepes Suzette, Cherries Jubilee,
Peppercorn Beef Flambé).
c) Clean ventilating fans frequently. Grease should not be allowed
to accumulate on fan filter.
d) Use proper pan size. Always use cookware appropriate for
the size of the surface element.
WARNING:
THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:
a) SMOTHER FLAMES with a close-fitting lid, cookie sheet, or
metal tray, then turn off burner. BE CAREFUL TO PREVENT
BURNS. If the flames do not go out immediately, EVACUATE
AND CALL THE FIRE DEPARTMENT.
b) NEVER PICK UP A FLAMING PAN - You may be burned.
c) DO NOT USE WATER, including wet dishcloths or towels -
a violent steam explosion will result.
d) Use an extinguisher ONLY if:
I.
II. The fire is small and contained in the area where it started.
III. The fire department is being called.
IV. You can fight the fire with your back to an exit.
WARNING:
DUCTWORK.
www.airkinglimited.com
Power Unit
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, DO
TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
TO REDUCE THE RISK OF INJURY TO PERSONS IN
You know you have a Class ABC extinguisher, and you
already know how to operate it.
TO REDUCE THE RISK OF FIRE, USE ONLY METAL
1 of 12

Advertisement

Table of Contents
loading

Summary of Contents for Air King ESSEV28

  • Page 1: General Safety Information

    IMPORTANT INSTRUCTIONS - OPERATING MANUAL Power Unit Models: ESSEV28, ESSEV30 READ AND SAVE THESE INSTRUCTIONS READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE! RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
  • Page 2: Installation Instructions

    SECTION 4 INSTALLATION INSTRUCTIONS Installing the Insert CAUTION: MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL 2. Insert the power unit into the hole and secure to liner using the screws provided BEFORE STARTING INSTALLATION. with the Liner (Figure 3). SECTION 1 Preparing the Insert 1. Unpack hood from the carton and confirm that all pieces are present. In addition to the range hood you should have: 1 - Package containing: 1 - duct collar 4 - #8-32 screws 2 - Aluminum Grease Filters (shipped installed) 2 - 18 watt fluorescent lamps 1 - Instruction/Safety Sheet Figure 3 NOTE: Some hoods may be shipped with a protective plastic adhered to the underside...
  • Page 3: Troubleshooting Guide

    SECTION 9 Supply from home Maintenance CAUTION: MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL BEFORE SERVICING THE UNIT. Filters 1. Included with your unit are aluminum grease filters that should be washed at least once a month. The filters are dishwasher safe and should be washed in a mild soap or detergent. Hot (Black) Neutral (White) 2. To remove the filters, pull down on the handle tab until the filter releases from the unit. To reinstall, slide tab at rear of filter into slot in the unit. While holding in handle of filter, lift filter into place and release handle. The filter should snap securely into place (Figure 8). Ground (Green or Bare) Figure 5 From Hood 2. Attach the wire compartment to the power unit with two of the provided #6 blunt tipped screws (Figure 6).
  • Page 4: Limited Warranty

    ONE YEAR FROM THE DATE OF ORIGINAL PURCHASE OR UNTIL THE ORIGINAL PURCHASER OF THE PRODUCT SELLS OR TRANSFERS THE PRODUCT, WHICHEVER FIRST OCCURS AND IN NO EVENT SHALL AIR KING’S LIABILITY UNDER ANY EXPRESS OR IMPLIED WARRANTY INCLUDE (I) INCIDENTAL OR CONSEQUENTIAL DAMAGES FROM ANY CAUSE WHATSOEVER, OR (II) REPLACMENT OR REPAIR OF ANY HOUSE FUSES, CIRCUIT BREAKERS OR RECEPTACLES.
  • Page 5: Replacement Parts Diagram

    REPLACEMENT PARTS DIAGRAM # Qty. Description Replacement Part # 1 2 Screw 5S1999010 2 1 Collar Assembly 5S5299100 3 1 Gasket 5S1202054 4 2 Screw 5S1999010 5 1 Wire Compartment 5S1137003 6 10 Screw 5S1999111 7 1 Blower Plate 5S1137002 8 1...
  • Page 6 NOTES 6728028 Rev. A 7-10 www.airkinglimited.com 6 of 12...
  • Page 7: Instructions Générales De Sécurité

    INSTRUCTIONS IMPORTANTES – MODE D’EMPLOI Unité de puissance Modèles: ESSEV28, ESSEV30 LIRE ET CONSERVER CES INSTRUCTIONS LIRE SOIGNEUSEMENT AVANT DE TENTER D’ASSEMBLER, INSTALLER, OPÉRER OU DE RÉPARER LE PRODUIT DÉCRIT. PROTÉGEZ VOUS-MÊME ET LES AUTRES EN OBSERVANT TOUTE L’INFORMATION DE SÉCURITÉ. FAILLIR À SE CONFORMER AUX INSTRUCTIONS PEUT RÉSULTER EN BLESSURE PERSONNELLE GRAVE ET/OU EN DOMMAGE À...
  • Page 8 SECTION 4 INSTRUCTIONS D’INSTALLATION Installation de l’encastrement AVERTISSEMENT : ASSUREZ-VOUS QUE L’ALIMENTATIONE EST 2. Insérez l'unité de puissance dans le trou et fixez-la au revêtement utilisant les vis COUPÉE AU PANNEAU DE SERVICE AVANT DE COMMENCER L’INSTALLATION. fournies avec le revêtement (Figure 3). SECTION 1 Préparation de la unité de puissance 1. Unpack hood from the carton and confirm that all pieces are present. In addition to the range hood you should have: 1. Sortir la hotte de son emballage et confirmer que toutes les pièces sont présentes. En plus de la hotte, vous devriez avoir : 1 - Contenu de l’emballage : 1 - Collet de conduit 4 - Vis #8-32...
  • Page 9: Guide De Dépannage

    SECTION 9 Alimentation de la résidence Maintenance AVERTISSEMENT : ASSUREZ-VOUS QUE L’ALIMENTATIONE EST COUPÉE AU PANNEAU DE SERVICE AVANT D’EFFECTUER UN SERVICE SUR L’UNITÉ. Filtres 1. Des filtres anti-graisse en aluminium sont compris avec votre unité et ils doivent être lavés au moins une fois par mois. Les filtres vont au lave-vaisselle et doivent être lavés avec un détergent ou savon doux. 2. Pour retirer les filtres, tirez l’onglet de la poignée vers le bas jusqu’à ce que les filtres se dégagent de l’unité. Pour réinstaller, glissez l’onglet à l’arrière du filtre dans Vivant (noir) Neutre (blanc) la fente dans l’unité. Tout en maintenant la poignée ou le filtre, soulevez le filtre en place et relâchez la poignée. Le filtre doit cliquer solidement en place (Figure 8). Terre (vert ou nu) Figure 5 De la hotte 2. Fixez le compartiment de câblage à l’unité de puissance avec deux des vis #6 à...
  • Page 10: Garantie Limitée

    AN DE LA DATE DE L'ACHAT ORIGINAL OU JUSQU'À CE QUE L'ACHETEUR ORIGINAL DU PRODUIT VEND OU TRANSFÈRE LE PRODUIT, CELUI QUI SE PRODUIT EN PREMIER ET DANS AUCUN CAS AIR KING N’ASSUME AUCUNE RESPONSABILITÉ EXPRESSE OU TACITE POUR (I) DES DOMMAGES ACCIDENTELS OU INDIRECTS DE N’IMPORTE QUELLE CAUSE, OU (II) LE REPLACEMENT OU LA RÉPARATION DE TOUS FUSIBLES, DISJONCTEURS OU RÉCEPTACLES DE MAISON.
  • Page 11 TABLEAU DES PIÈCES DE RECHANGE # de pièce de # Qté. Description remplacement 1 2 Vis 5S1999010 2 1 Assemblement de collier 5S5299100 3 1 Ampoule 5S1202054 4 2 Vis 5S1999010 5 1 Compartiment à câblage 5S1137003 6 10 Vis 5S1999111 7 1 Plaque de ventilateur...
  • Page 12 REMARQUE 6728028 Rev. A 7-10 www.airkinglimited.com 12 of 12...

This manual is also suitable for:

Essev30

Table of Contents