Building-In Instructions - Moffat U29065 User Manual

Building-in instructions

Before carrying out any work, remove the plug
from the power socket.
Grid preparation
Left door opening:
Remove the left side (A) of the grid cutting it
from the rear (see figure).
A
DO002/2
Right door opening:
Remove the right side (B) of the grid cutting it
from the rear (see figure).
To position the grid on the appliance proceed as
follows:
Apply the grid to the base of the appliance by
pushing on to the clasps (a) until they click.
DO013
Building in the appliance under a
worktop
The dimensions of the recessed installation
area must correspond with those indicated in
the figure.
a
DO001
18
B
a
Installation kit
1. Two cabinet securing brackets are supplied
with the installation pack. They need to be
assembled onto the cabinet prior to cabinet
being pushed into the Kitchen aperture.
- To fit these brackets remove the two screws
at the top left and right hand front corners of
the cabinet.
- Position the two brackets as shown in the
figure and replace the two securing screws.
Left hand bracket
Right hand bracket