Table of Contents
Advertisement
Add: Click Add and drag a rectangle area where you want to check. The search area will
overlay a transparent red mask.
Delete: Click Delete and drag a rectangle area where you want to remove the region.
Default: Click Default to select full image for motion detection.
Show Search Image: Check Show Search Image to display the searching video sequence
or un-check this box to only show the image once the event found.
Show Detect Mark: Check Show Detect Mark to display the detect result on the image by
pink rectangles.
Sensitivity: Select Sensitivity to define the sensitivity of detection. The higher value means
the event will be triggered easier.
Detect Interval: Select Detect Interval to define the interval of motion detection. If set longer
value, it means the system will use less CPU computing power to check motion detection.
Start / Continue: When the event has been triggered, the window on the right side will
display the triggered image. If the event is not matched your expectation, click the "Continue"
button to search next event.
OK: If you found the matched event, click OK to return to the playback panel, and all playing
channels will be synchronized to the same timestamp of the event.
Cancel: Click Cancel to abort this motion search job.
5.9.6 Sequential Search
Click mouse right button on the channel which you want to do sequential search, and then select
Sequential Search from the popup menu.
Sequential Search Window:
65
Advertisement
Table of Contents
