Building In; Door Reversibility - Electrolux U01327 Operating And Installation Instructions

Instructions for totally built-in
appliances

Door reversibility

Recess dimensions
Height 880 mm
Depth 550 mm
Width 560 mm
The applianceÕs door has been locked in position
for transport by means of pins on both sides.
According to the door opening direction, remove
relevant pins at the top and at the bottom.
To ensure adequate ventilation, allow the clearances
shown in figure.
In addition, it is necessary that the cabinet has a
ventilation recess with the following dimensions:
depth 50 mm
width 540 mm
Push appliance into housing until top edge of the
appliance (A) touches the kitchen unit.
If there is a gap after the appliance has been fitted
into the cabinet, slide the rubber in his strip provided
onto the top edge (A) of the appliance.
Open the door and push the appliance against the
side of the kitchen unit opposite to that of appliance
hinges.
Fasten the appliance with 4 screws provided in the
kit included with the appliance.
Snap ventgrille (C) and hinge cover (D) into position.
18
50 mm
D567
W
D H
PR01
A
D022
A
D265
D
D727
min.
2
cm 200
C