Table of Contents
Advertisement
Installation
Caution! Read the "Safety Information" carefully for
your safety and correct operation of the appliance
before installing the appliance.
Positioning
Install this appliance at a location where the ambient tem-
perature corresponds to the climate class indicated on the
rating plate of the appliance:
Climate
class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
Door reversibility
The door of the appliance
opens to the right. If you
want to open the door to the
left, do these steps before
you install the appliance:
Ventilation requirements
The airflow behind the ap-
pliance must be sufficient.
Ambient temperature
• Loosen the upper pin
and remove the spacer.
• Remove the upper pin
and the door.
min.
50 mm
200 cm
2
Electrical connection
Before plugging in, ensure that the voltage and frequency
shown on the rating plate correspond to your domestic
power supply.
The appliance must be earthed. The power supply cable
plug is provided with a contact for this purpose. If the
domestic power supply socket is not earthed, connect the
appliance to a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
• Remove the door.
• Loosen the lower pin.
Installing the appliance
Caution! Make sure that the mains cable can move
freely.
Do the following steps:
min.
200 cm
2
On the opposite side:
• Install the lower pin.
• Install the door.
• Tighten the spacer and
tighten the upper pin.
9
Advertisement
Table of Contents
