Specifications - Panasonic PT-D10000 Specifications

S F
P E C I L
3-Chip DLP™ Projector

Specifications

Main Unit
Power supply: North America:
Europe, Asia
Power consumption:
DLP™ chip: Panel size:
Display method:
Pixels:
Lens:
Lamp:
Screen size:
Brightness * 1 :
Center-to-corner uniformity *
Contrast * 1 :
Resolution:
Scanning frequency: RGB:
YP
S-Video/Video:
Optical axis shift*: Vertical:
Horizontal:
Keystone correction range:
Installation:
Terminals: DVI-D IN:
RGB1 IN:
RGB2 IN:
VIDEO IN:
As of November 2008
E
120 V AC, 15 A, 60 Hz
220–240 V AC, 15 A, 50/60 Hz
1,450 W (25 W in standby mode with fan stopped)
0.95˝ diagonal (4:3 aspect ratio)
DLP™ device x 3 (R, G, B), DLP™ projection system
1,470,000 (1,400 x 1,050) x 3, total of 4,410,000 pixels
Optional powered zoom/focus lenses
250 W UHM lamp x 4
70 – 600 inches, 4:3 aspect ratio
(70 – 300 inches with the ET-D75LE5, 4:3 aspect ratio)
10,000 lumens (four-lamp operation mode)
1 : 90%
5,000:1 (full on/full off, in dynamic iris 3 mode)
1,400 x 1,050 pixels (Input signals that exceed this resolution will be
converted to 1,400 x 1,050 pixels.)
Horizontal: 15 –100 kHz, Vertical: 24 – 120 Hz*
Dot clock: 20–162 MHz
P (YC C ): 480i: f
B R B R
480p: f
720/60p: f
1035/60i: f
1080/50i: f
1080/24p: f
1080/30p: f
1080/50p: f
Horizontal: 15.75/15.63 kHz, Vertical: 50/60 Hz,
(NTSC, NTSC4.43, PAL, PAL60, PAL-N, PAL-M, SECAM)
±50% (±40% with the ET-D75LE6) from center of screen, powered
±30% (±20% with the ET-D75LE6) from center of screen, powered
Vertical: ±40° (±22° with the ET-D75LE5, ±28° wih the ET-D75LE6)
Ceiling/floor, front/rear
DVI-D 24-pin x 1, DVI 1.0 compliant, HDCP compatible, single link
BNC x 5
R, G, B: G: 0.7 Vp-p (1.0 Vp-p for sync on G), 75 ohms,
B, R: 0.7 Vp-p, 75 ohms
HD, VD, SYNC: 1.4–5.0 Vp-p, positive/negative automatic
Y, P , P Y: 1.0 p-p, 75 ohms (incl. sync signal), P
B R
0.7 Vp-p (1.0 Vp-p for sync on G), 75 ohms
NOTE: HD/SYNC, and VD terminals do not accept 3-value direct sync signals.
D-sub HD 15-pin x 1
R, G, B: 0.7 Vp-p (1.0 Vp-p for sync on G), 75 ohms
HD, VD, SYNC: TTL, high impedance, positive/negative automatic
VD: 1.4–5.0 Vp-p, positive/negative automatic, 75 ohms
Y, P , P Y: 1.0 p-p, 75 ohms (incl. sync signal), P
B R
NOTE: HD/SYNC, and VD terminals do not accept 3-value direct sync signals.
BNC x 1, 1.0 Vp-p, 75 ohms
15.75 kHz; f 60 Hz, 576i: f
H V
31.50 kHz; f 60 Hz, 576p: f
H V
45.00 kHz; fV 60 Hz, 720/50p: f
H
33.75 kHz; f 60 Hz, 1080/60i: f
H V
28.13 kHz; f 50 Hz, 1080/25p: f
H V
27.00 kHz; f 24 Hz, 1080/24sF: f
H V
33.75 kHz; f 30 Hz, 1080/60p: f
H V
56.25 kHz; f 50 Hz
H V
PT-D10000
2 ,
15.63 kHz; f 50 Hz,
H V
31.25 kHz; f 50 Hz,
H V
37.5 kHz; fV 50 Hz,
H
33.75 kHz; f 60 Hz,
H V
28.13 kHz; f 25 Hz,
H V
27 kHz; f 48 Hz,
H V
67.5 kHz; f 60 Hz,
H V
/P : 0.7 Vp-p, 75 ohms
B R
/P : 0.7 Vp-p, 75 ohms
B R
< 2 >