Panasonic Viera TC-L50ET60 Quick Setup Manual page 9

Assembly screws
(silver) (4)
M5 × 18
Attaching the pedestal
A
1
C
E
Warning
Do not disassemble or modify the pedestal.
Otherwise, the TV may fall over and become damaged, and personal injury may result.
Caution
Do not use any pedestal other than that provided with this TV.
Otherwise, the TV may fall over and become damaged, and personal injury may result.
Do not use the pedestal if it becomes warped or physically damaged.
If you use the pedestal when it is physically damaged, personal injury may result. Contact your
nearest Panasonic Dealer immediately.
During set-up, make sure that all screws are securely tightened.
If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal
will not be strong enough to support the TV, and it might fall over and become damaged, and personal
injury may result.
When removing the pedestal, do not remove the pedestal by any methods other than the
specified procedure. (Above)
Otherwise, the TV and/or pedestal may fall over and become damaged, and personal injury may
result.
Hook
Attaching the pedestal to TV
Assembly screws
(black) (4)
M4 × 10
2
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way when using
the wall-hanging bracket or repacking the TV.
Installing the remote's batteries
Pull open
Note the correct
polarity (+ or -).
Bracket Cover
Remove the assembly screw
Pull out the cover.
Lift the TV from the pedestal.
Remove the assembly screws
Caution
Incorrect installation may cause battery
Close
leakage and corrosion, resulting in
damage to the remote control.
•
Do not mix old and new batteries.
•
Do not mix different battery types (such
as alkaline and manganese batteries).
•
Do not use rechargeable (Ni-Cd) batteries.
Do not burn or break batteries.
Base
B
D
3
from the cover.
from the bracket.
9