2.4 進階選單(Advanced menu)
進階選單可讓您改變中央處理器與其他系統裝置的細部設定。
注意!在您設定本進階選單的設定時,不正確的數值將導致系統
損毀。
Main
Advanced
Jumperfree Configuration
USB Configuration
TPM Configuration
CPU Configuration
Chipset
Onboard Devices Configuration
PCIPnP
2.4.1 JumperFree 設定(JumperFree Configuration)
Advanced
Configure System Frequency/Voltage
AI Tuning
DRAM Frequency
AI Tuning [Standard]
本項目可滿足您對於中央處理器超頻的渴望,提供預先設定好的超頻比
率,您只需選擇設定值即可超頻。設定值有:[Manual] [Standard]。
以下的項目只有在 AI Tuning 項目設定為 [Manual] 時才會出現。
CPU Frequency [xxx]
本項目指定從時脈產生器所產生的頻率數值,送至系0統匯流排與 PCI 匯
流排。中央處理器的運作時脈(CPU Speed)是由倍頻與外頻相乘而得。本
項目的數值由 BIOS 程式自動偵測而得,也可以使用「+」或「-」按鍵來調
整。數值變更的範圍由 100 至 400 MHz。
第二章:BIOS 程式設定
-1
Power
Boot
v02.58 (C)Copyright 1985-2006, American Megatrends, Inc.
[Standard]
[Auto]
BIOS SETUP UTILITY
Tools
Exit
BIOS SETUP UTILITY
Adjust system
Frequency/Voltage,etc.
Select Screen
Select Item
Enter Go to Sub Screen
F1
General Help
F10
Save and Exit
ESC
Exit
Select the target CPU
frequency, and the
relevant parameters
will be auto-adjusted.
Frequencies higher
than CPU manufacturer
recommends are not
guaranteed to be
stable. If the system
becomes unstable,
return to the default.