Asus P5B Installation Manual page 51

4. JMicron JMB363
This connector is for a Serial ATA signal cable. This connector supports
a Serial ATA hard disk drive that you can configure for RAID through the
onboard Serial ATA RAID controller.
The JMicron controller mode item in the BIOS is set to [AHCI] by default,
allowing you to use the connectors to build a RAID set. See section "..5
Onboard Device Configuration" for details.
P5B SATA RAID Connector
Before creating a RAID set using Serial ATA hard disks, make sure that you
have connected the Serial ATA signal cables and installed Serial ATA hard disk
drives; otherwise, you cannot enter the JMicron
BIOS setup during POST.
5. Digital audio connector (4-1 pin SPDIF_OUT)
This connector is for an additional Sony/Philips Digital Interface (S/PDIF)
port(s). Connect the S/PDIF Out module cable to this connector, then install
the module to a slot opening at the back of the system chassis.
P5B Digital Audio Connector
The S/PDIF module is purchased separately.
ASUS P5B
Serial ATA RAID connector (7-pin SATA_RAID)
®
SATA_RAID
JMB6 RAID utility and SATA
®
SPDIF_OUT
2-27