Table of Contents
Advertisement
Using either method, the client wireless device will attempt to detect the WPS signal from the
router and establish a wireless connection in the time allotted.
•
If no connection is detected, then no SSID or security settings are configured on the router.
•
If a connection is established, the router WPS screen displays a message confirming that the
wireless client was successfully added to the wireless network. (The router has generated an
SSID, implemented WPA/WPA2 wireless security (including a PSK security password) on the
router and has sent this configuration to the wireless client.)
4.
Note the new SSID and WPA/WPA2 password for the wireless network.
To access the Internet from any computer connected to your wireless modem router, launch
a browser such as Microsoft Internet Explorer or Mozilla Firefox. You should see the wireless
modem router's Internet LED blink, indicating communication to the ISP.
i
If you are planning a mixed network of WPS capable devices and non-WPS capable devices,
NETGEAR suggests that you set up your wireless network and security settings manually first,
and use WPS only for adding additional WPS capable devices.
For more information on setting up your wireless network and configuring your wireless security
settings, see the User Manual located online at help.optuszoo.com.au/help/cable
i
If you require Wi-Fi support for your Optus-supplied NETGEAR Wi-Fi ADSL Modem Router and
Wi-Fi Adapter, please contact NETGEAR on 1300 361 254.
8
USING PUSH 'N' CONNECT (WPS) TO CONFIGURE YOUR WIRELESS
1382777E 0411 166321.indd 8
7/04/11 10:42 AM
Hide quick links:
Advertisement
Table of Contents
