AEG FAVORIT 86070 Vi User Information page 32

Malfunction
1 short warning tone,
continuously repeated,
can be heard,
the cycle indicator for the
selected dishwashing cycle
is flashing:
the WATER control indi-
cator lights up:
fault code
played in the multi-dis-
play:
(Problems with water in-
let)
2 short warning tones,
continuously repeated,
can be heard,
the cycle indicator for the
selected dishwashing cycle
is flashing,
fault code
played in the multi-dis-
play. (Problems with water
outflow)
3 short warning tones,
continuously repeated,
can be heard,
Fault code
played in the multi-dis-
play.
1 long warning tone can
be heard,
The SPRAY ARM control
indicator is lit.
The DOOR control indica-
tor is lit.
32
Water tap is blocked with
limescale or faulty.
The tap is turned off.
The filter (where present) in
the threaded hose fitting
on the tap is blocked.
Filters in the base of the
Å 10
is dis-
dishwasher compartment
are blocked.
Water inlet hose
has not been correctly posi-
tioned.
The sink outlet is blocked.
Water drain hose
has not been correctly posi-
Å 20
is dis-
tioned.
The anti-flood system has
Å 30
is dis- been triggered.
The upper basket spray arm
is jammed.
The door of the dishwasher
is open.
Possible cause Remedy
Check the water tap and
have it repaired if necessary.
Turn the tap on.
Clean the filter in the
threaded hose fitting.
Cancel the dishwashing cy-
cle (see chapter: Starting a
dishwashing cycle),
clean filters (see chapter:
Cleaning the filters),
then start the dishwashing
cycle again.
Check the position of the
hose.
Clean out sink outlet.
Check the position of the
hose.
First shut off the water tap,
then switch off the appli-
ance and contact the Cus-
tomer Care Department.
Open the door carefully
Hot steam may escape when
the door is opened. There is
a risk of scalding. Arrange
the dishes and cutlery in the
baskets so that the spray
arm above can rotate freely.
Close the dishwasher door.
Close the dishwasher door.