Moving The Machine; What To Do If - AEG FAVORIT 86011 VI User Manual

30

What to do if...

Moving the machine

If you have to move the machine (moving house etc....):
1. Unplug it.
2. Turn the water tap off.
3. Remove the water inlet and discharge hoses.
4. Pull the machine out together with the hoses.
Avoid over tilting the machine during transportation.
What to do if...
The dishwasher will not start or stops during operation. Certain problems are due
to the lack of simple maintenance or oversights, which can be solved with the help
of the indications described in the chart, without calling out an engineer.
Switch off the dishwasher and carry out the following suggested corrective actions.
Fault code and malfunction
• continuous flashing of the light of the run-
ning programme
• point-shaped optical signal is flashing
•
appears in the digital display.
• intermitted audible signal
The dishwasher does not fill with water.
• continuous flashing of the light of the run-
ning programme
• point-shaped optical signal is flashing
•
appears in the digital display.
• intermitted audible signal
The dishwasher will not drain.
Possible cause and solution
• The water tap is blocked or furred with lime-
scale.
Clean the water tap.
• The water tap is turned off. Turn the water tap
on.
• The filter (where present) in the threaded hose
fitting at the water inlet valve is blocked.
Clean the filter in the threaded hose.
• The water inlet hose has not been correctly
laid or it is bent or squashed.
Check the water drain hose connection.
• The sink spigot is blocked.
Clean out the sink spigot.
• The water drain hose has not been correctly
laid or it is bent or squashed.
Check the water drain hose connection.