Installing The Guard; Operation - Toro 51358 - Company The 13" Trim Operator's Manual

Setup
Adjusting the Assist
Handle
1. Loosen the
knob (A), then move the
assist handle up or
down the shaft to your
desired height.
2. Pivot the assist
handle to a comfortable
position (B), then tighten
the knob.

Installing the Guard

1. Slide the guard onto the trimmer, ensuring that
the tabs on the guard slide into the rectangular
holes in the trimmer housing on both sides.
2. Snap the guard into
place and secure the
hooks under the guard
on to the trimmer.
3
A
B
m–7852
m-6314/6696
m-6326
3352-881

Operation

Warning
During operation, the trimmer may throw objects
in the operator's or a bystander's direction,
causing injury.
S
Wear safety goggles or other suitable eye
protection, long pants, and shoes while
operating the trimmer.
S
Keep bystanders away from the work area.
Warning
When the trimmer is running the cutting head is
spinning. If you contact the cutting line or cutting
head, you could be injured.
S
Keep the cutting head away from your hands,
feet, and bystanders. Keep the guard in place
and in working order.
S
Wear shoes and long pants when using the
trimmer.
S
Ensure that the cutting head has stopped and
you disconnect the trimmer from the power
source before you service or examine the
cutting head. Do not start the trimmer unless
your hands are on both handles and the
cutting head is down near the ground.
S
Do not allow the trimmer to cut into the cord.