Setting Read Command; Temp Read Command; Lamp Mode Read Command; Modification - Sanyo PLC-XW300 - 3000 Lumens Manual

PLC-XW200/250/300 Basic Serial Command Specifications

7.7. Setting Read Command

Command "CR4" [CR]
Detail Get screen setting status such as Ceiling / Rear.
Acceptable
Response
Unacceptable

7.8. Temp Read Command

Command "CR6" [CR]
Get the temperature data inside the projector.
Detail With some temperature sensors installed in the projector, it is possible to get all
the temperature at once.
Acceptable
Response
Unacceptable

7.9. Lamp Mode Read Command

Command "CR7" [CR]
Get lamp mode status.
Detail
For 1 lamp projector, get if it is lighting or not.
Acceptable
Response
Unacceptable

8. Modification

Version
V1.01 2009.10.28
"%1" [CR]
"11"[CR] = Normal Screen Setting
"10"[CR] = Picture is top/bottom reversed.
(Status: Rearÿ Ceiling ON)
%1
"01"[CR] = Picture is left/right reversed. (Status: Rear ON)
"00"[CR] = Picture is top/bottom and left/right reversed.
(Status: Ceiling ON
"?" [CR]
"%1_%2_%3" [CR]
%1ÿ Temperature of sensor 1
%2ÿ Temperature of sensor 2
%3ÿ Temperature of sensor 3
Temperature data is shown as "00.0".
When the temperature goes down to -, the first character
%1
becomes "-" instead of a space, like "-05.5" [CR].
%2
When no temperature data can be returned due to hardware
%3
problems, the first character becomes "E" like"E00.0" [CR].
When several temperature sensors are equipped, Responses are
returned continuously.
"_31.5 _ _35.2 _ _33.4"[CR]
The first data is sensor 1, then one space, and the data of sensor
2 follows.
"ÿ "[CR]
"%1" [CR]
"00" [CR]=Light is out.
%1
"01" [CR]=Light is on.
"ÿ "[CR]
History
Date
Added new model (XW300)
22/22
)
Modification