Table of Contents
Advertisement
6. Install the Intel(R) Rapid Storage software via the CD-ROM included with
your motherboard or after downloading it from the Internet. This will add
the Intel(R) Rapid Storage Console which can be used to manage the
RAID configuration.
7. After setting up a "RAID Ready" system as the above steps, you can
follow the procedures of the next section to migrate the system to
RAID 0, RAID 1 or RAID 5.
2.3.3 Migrating a "RAID Ready" System to RAID 0,
RAID 1 or RAID 5
If you have an existing "RAID Ready" system, then you can use the
following steps to perform a migration from a single non-RAID
configuration to a two drive RAID 0, RAID 1 configuration or three
drive RAID 5 configuration. To prepare for this, you will need another
SATA / SATAII / SATA3 hard drive with a capacity equal to or greater
than that currently being used as the source hard drive.
1. Physically attach one additional SATA / SATAII / SATA3 hard drive to the
SATAII / SATA3 port not being used. Note the serial number of the hard
drive already in the system; you will use this to select it as the source
hard drive when initiating the migration.
®
2. Boot Windows
, install the Intel(R) Rapid Storage Manager software, if
not already installed, using the setup package obtained from a CD-ROM
or from the Internet. This will install the necessary Intel Storage Utility
and start menu links.
3. Open the Intel Storage Utility from the Start Menu and select "Create
RAID volume from Existing Hard Drive" from the Actions menu. This will
activate the Create RAID volume from Existing Hard Drive Wizard. Click
through the dialogs as prompted. It's important to understand what will
occur during the migration process because any data on the destination
hard drive will be lost.
4. Once the migration is complete, reboot the system. If you migrated to a
RAID 0 volume, use Disk Management from within Windows
partition and format the empty space created when the two hard drive
capacities are combined. You may also use third-party software to
extend any existing partitions within the RAID volume.
8
®
in order to
Advertisement
Table of Contents
