Events - Axis M3005-V User Manual

AXIS M3005-V Network Camera

Events

Events
The Axis product can be configured to perform actions when different events occur, for example, start a recording when motion is
detected. The set of conditions that defines how and when the action is triggered is called an Action Rule.
Available Action Rule triggers and conditions include:
Applications — use installed applications to trigger the rule, see
•
Detectors
•
Motion Detection — trigger the rule when motion is detected, see
-
- Tampering — trigger the rule when tampering is detected, see
Hardware
•
Network — trigger the rule if network connection is lost or restored. This can for example be used to start
-
recording to the SD card.
Input Signal
•
- Manual Trigger — trigger the rule using the Manual Trigger button in the Live View page, see
the Live View Page on page 8
and configuration.
PTZ
•
• Storage
Available — trigger the rule when the storage device is unmounted or removed. This can for example be
-
used to send maintenance notifications.
Full — trigger the rule when the storage device is full. Under normal operation, the oldest recordings will be
-
overwritten to prevent the storage device from becoming full.
Locked — trigger the rule if the storage device is locked (write protected).
-
System
•
System Initializing — trigger the rule when the product is being started. This can for example be used to send a
-
notification when the product restarts.
Time
•
Recurrence — trigger the rule periodically, see
-
an image every 5 minutes.
Use Schedule — trigger the rule according to the selected schedule, see
-
Available actions include:
PTZ Control
•
Preset Position — go to a preset position.
-
Guard Tour — start a guard tour, see
-
Record Video — record video to a selected storage.
•
• Send Images — send images to a recipient.
Send Notifications — send a notification message to a recipient.
•
Applications on page 27
. This can for example be used to validate actions during product installation
Recurrences on page 30
Guard Tour on page 22
28
.
Motion Detection on page 24
Camera Tampering on page 24
. This can for example be used to upload
Schedules on page 30
.
.
.
Controls on
.