Using Device - Lenovo 892204U - C200 8922 - Celeron M 1.6 GHz Manual

Using Device

3. The password dialog box will be displayed. Type the new password, and
press Enter.
4. when prompted to confirm the password, type the password again. If
you type the password correctly, the password will be installed.
To delete a previously set Power-On Password, do the following :
1. From the Security menu, select Set Power-On Password and press
Enter.
2. The password dialog box will be displayed. Enter New Password and
confirm New Password dialog. A setup notice will display that changes
have been saved.
3. Select Exit.
4. Select Save changes and Exit.
After the password is set, you may select the "Advanced" Menu for device setup.
Device is used to enable or disable user access to the following device
ATA Drives Setup
To set Device, do the following:
1. Start the Setup Utility program (see "Starting the Setup Utility program"
on page 16).
2. From the Setup Utility program menu, select Devices.
3. Select ATA Drives Setup.
4. Select Disabled or Enabled and press Enter.
5. Return to the Setup Utility program menu and press F10 to save
configuration changes and exit setup.
Note
If you do not want to save the settings, select Exit and select Discard
changes and Exit.You can set others such as Audio Setup and
Network Setup. See the information displayed on the right side of
the screen.
Chapter 5. Using the Setup Utility
When this feature is set to Disable,
the device of ATA Drives Setup
is disabled and will not be displayed in
the system configuration.
19