Using The Secure Erase Utility; Starting Dos Ssd Application - Samsung MZ-7PC128N User Manual

to complete the process, and shut down the PC.
4.4 Using the Secure Erase
Utility
IMPORTANT:
Utility has been properly installed. Before proceeding, be sure to
successfully complete the entire Secure Erase Utility installation process
as instructed in the section beginning on page 35.

Starting DOS SSD Application

Warning:
mode. Please check your BIOS settings.
Follow the steps below:
1. Configure the USB Flash Drive as a primary booting device in the
BIOS.
NOTE: If you are not sure how to set up your computer BIOS, please
check the user manual of your computer system or motherboard.
2. Boot the Laptop/PC in DOS mode from the USB Memory device.
The following section assumes that the Secure Erase
The Secure Erase Utility will execute only in IDE/ATA or AHCI
44