Water Filter Certifications - Whirlpool WRS325FDAM Installation Instructions And Owner's Manual

ICE AND WATER Possible Causes and/or Recommended Solutions
Water is leaking or NOTE: After dispensing, a few additional drops of water are normal.
dripping from the
Glass was not held under the dispenser long enough - Hold the glass under the dispenser for
dispenser
2 to 3 seconds after releasing the dispenser pad/lever.
New installation, or water filter was recently installed or replaced - Air in the water lines causes the
water dispenser to drip. Flush the water system to remove the air in the water lines. See "Water and Ice
Dispensers" in the User Instructions or User Guide.
Residual ice in the dispenser chute is melting - Make sure the ice chute is free of ice shavings or pieces.
Water is leaking Water line connections are not fully tightened - Make sure all connections are firmly tightened. See
from the "Connect Water Supply."
back of the
refrigerator
Water from the NOTE: Water from the dispenser is chilled to 50°F (10°C).
dispenser is
New installation - Allow 24 hours after installation for the water supply to cool completely.
not cool enough
Recently dispensed a large amount of water - Allow 24 hours for the new water supply to cool
(on some models)
completely.
Water has not been recently dispensed - The first glass of water may not be cool. Discard the first glass
of water dispensed.
Refrigerator is not connected to a cold water pipe - Make sure the refrigerator is connected to a cold
water pipe. See "Water Supply Requirements."

WATER FILTER CERTIFICATIONS

15