Asus MES-B User Manual page 30

3. HARDWARE SETUP
7) Chassis, CPU , & Power Supply Fan Connectors (3-pin CHA_, CPU_, PWR_FAN)
These connectors support cooling fans of 500mA (6 Watts) or less. Orientate
the fans so that the heat sink fins allow airflow to go across the onboard heat
sink(s) instead of the expansion slots. Depending on the fan manufacturer, the
wiring and plug may be different. The red wire should be positive, while the
black should be ground. Connect the fan's plug to the board taking into consid-
eration the polarity of the this connector. NOTE: The "Rotation" signal is to
be used only by a specially designed fan with rotation signal.
WARNING!
The CPU and/or motherboard will overheat if there is no airflow
across the CPU and onboard heatsinks. Damage may occur to the motherboard
and/or the CPU fan if these pins are incorrectly used. These are not jumpers,
do not place jumper caps over these pins.
MES-B
R
MES-B 12Volt Cooling Fan Power
8) Wake-On-LAN Connector (3-pin WOL_CON)
This connector connects to a LAN card with a Wake-On-LAN output, such as
the ASUS PCI-L101 Ethernet card (see 7.1 ASUS PCI-L101 Fast Ethernet Card).
The connector powers up the system when a wakeup packet or signal is received
through the LAN card.
IMPORTANT:
This feature requires that Wake On LAN is set to Enabled (see
4.5.1 Power Up Control) and that your system has an ATX power supply with at
least 720mA +5V standby power.
MES-B
R
MES-B Wake-On-LAN Connector
30
Power Supply Fan
CPU Fan Power
GND
+12V
Rotation
GND
+12V
Rotation
Chassis Fan Power
Ground
+5 VSB
ASUS MES-B User's Manual
PME