Configuring And Mounting The Drive; Handling And Static-Discharge Precautions - Seagate ST3160023AS - Barracuda 160 GB Hard Drive Product Manual

3.0

Configuring and mounting the drive

This section contains the specifications and instructions for configuring and mounting the drive.
3.1

Handling and static-discharge precautions

After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic dis-
charge (ESD) hazards. Observe the following standard handling and static-discharge precautions:
Caution:
• The SeaShell™ replaces electrostatic discharge (ESD) bags. The SeaShell package is a shock-ribbed,
transparent clamshell enclosure that limits a drive's exposure to ESD and also protects against external shocks
and stresses. The design permits attaching cables, software loading and label/barcode scanning without
removing the drive from the SeaShell. This minimizes handling damage. Keep the drive in the SeaShell
package until you are ready for installation.
• Before handling the drive, put on a grounded wrist strap, or ground yourself frequently by touching the metal
chassis of a computer that is plugged into a grounded outlet. Wear a grounded wrist strap throughout the entire
installation procedure.
• Handle the drive by its edges or frame only.
• The drive is extremely fragile—handle it with care. Do not press down on the drive top cover.
• Always rest the drive on a padded, antistatic surface until you mount it in the computer.
• Do not touch the connector pins or the printed circuit board.
• Do not remove the factory-installed labels from the drive or cover them with additional labels. Removal voids
the warranty. Some factory-installed labels contain information needed to service the drive. Other labels are
used to seal out dirt and contamination.
Barracuda 7200.7 Serial ATA Product Manual, Rev. N 19