Table of Contents
Advertisement
APPENDIX
TROUBLESHOOTING
I,I,I Check to see if there is any object between the product and the remote control
causing obstruction.
Ensure you are pointing the remote control
directly at the TV.
Ensure that the batteries are installed with correct
polarity
(+ to +, - to -).
Ensure that the correct
remote operating
mode is set: TV, VCR etc.
Install new batteries.
m
z
_D
x
Check whether
the product
is turned on.
Try another channel. The problem may be with the broadcast.
Is the power cord inserted
into wall power outlet?
Check your antenna direction
and/or
location.
Test the wall power outlet,
plug another
product's
power cord into the outlet
where the product's
power cord was plugged
in.
This is normal, the image is muted during the product
startup
process. Please
contact your service center, if the picture
has not appeared after five minutes.
Adjust Color in menu option.
Keep a sufficient
distance between the product
and the VCR.
Try another channel. The problem may be with the broadcast.
Are the video cables installed
properly?
Activate
any function
to restore the brightness
of the picture.
Check for local interference
such as an electrical
appliance
or power tool.
Station or cable product
experiencing
problems,
tune to another
station.
Station signal is weak, reorient
antenna to receive weaker station.
Check for sources of possible
interference.
Check antenna (Change the direction
of the antenna).
8O
Advertisement
Table of Contents
