Table of Contents
Advertisement
Dual-Monitor Setup
You can set the display to output from two monitors on the Change Display Configuration page.
(1) The same on both display (Clone)
Clone mode indicates that both displays in the
display pair show images of the same desktop.
(2) As one large horizontal desktop
(Horizontal span)
Horizontal Span mode indicates that both displays
in the display pair function as one wide virtual
desktop. The width of each display is half the
width of the total virtual desktop width.
(3) As one large vertical desktop
(Vertical span)
Vertical Span mode indicates that both displays in
the display pair function as one tall virtual desktop.
The height of each display is half the height of the
total virtual desktop height.
(Note)
Only "only use one display (Single)" mode
is available when SLI mode is enabled.
:
(Note)
- 21 -
Select your preferred nView display modes here.
• only use one display (Single)
• The same on both display (Clone)
• As one large horizontal desktop (Horizontal span)
• As one large vertical desktop (Vertical span)
• Configured independently from each other
(Dualview)
Clone Mode
Horizontal Span Mode
Vertical Span Mode
Software Installation
Advertisement
Table of Contents
