VTech Power Zone Edge User Manual page 38

close
print
type
thing
pause
wait
readchar (rc)
readword (rw)
readlist (rl)
cleartext (ct)
pots
erase (er)
eraseall (erall)
6. Flow control Commands
if <condition> then [commands]
if <condition> then [commands1] If <condition> is TRUE then the commands
else [commands2] in [commands1] are executed. Otherwise the
label <label>
go <label>
n close a device.
n print its inputs to the output stream.
n print its inputs on the screen, and the prompt appears
after the last character printed.
n output the value associated with the variable named
in the input.
temporarily halt the execution of a procedure.
n insert a pause before the next instruction is run. The
length of the pause is the input to WAIT times 1/30
of a second.
output the first character from the input stream. If no
character is waiting to be read, READCHAR waits
for input from the keyboard.
output in the form of a word from the input stream.
If no line is waiting to be read, READWORD waits
for input from the keyboard.
output in the form of a list from the input stream. If
no line is waiting to be read, READLIST waits for
input from the keyboard.
clear output window content.
print the titles of all user-defined procedures. POTS
stands for "Print Out Titles".
n remove the definition of its input from the workspace.
The input to ERASE must be a procedure name.
remove all procedures and variables from the
workspace.
The <condition> must result in a value of either TRUE
or FALSE. If the <condition> is TRUE then the commands
in [commands] are executed.
commands in [commands2] are executed.
This command marks a location in the program so
execution of LOGO commands can be started or resumed
at this point with a GO command.
<label> must be a label defined elsewhere in the program
with a LABEL command. The GO command causes
command execution to jump to the location of the LABEL
command with the corresponding <label>.
30