Table of Contents
Advertisement
3.
IDE connectors (40-1 pin PRI_IDE; 40-1 pin SEC_IDE)
The onboard IDE connectors are for Ultra DMA 133/100/66 signal cable(s).
There are three connectors on each Ultra DMA 133/100/66 signal cable: blue,
black, and gray. Connect the blue connector to the
connector, then select one of the following modes to configure your device(s).
Single device
Two devices
•
•
If any device jumper is set as "Cable-Select," make sure all other device
jumpers have the same setting.
M2NPV-VM IDE connectors
1-30
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
M2NPV-VM
®
motherboard's IDE
Mode.of.
Cable.connector
device(s)
-
Black
Black
Master
Slave
Gray
Master
Black or gray
Slave
NOTE:.Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PIN 1
Chapter 1: Product introduction
Hide quick links:
Advertisement
Table of Contents
