Table of Contents
Advertisement
7) SATA3_0/1/2/3/4/5 (SATA 6Gb/s Connectors, Controlled by AMD SB850 South Bridge)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standards. Each SATA connector supports a single SATA device. The AMD SB850 controller
supports RAID 0, RAID 1, RAID 5, RAID 10, and JBOD. Refer to Chapter 5, "Configuring SATA Hard
Drive(s)," for instructions on configuring a RAID array.
• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard
drives are to be used, the total number of hard drives must be an even number.
• A RAID 5 configuration requires at least three hard drives. (The total number of hard drives
does not have to be an even number.)
• A RAID 10 configuration requires four hard drives.
Hardware Installation
SATA3_5
1
1
SATA3_4
SATA3_0
SATA3_3
7
1
1
7
SATA3_1
SATA3_2
- 24 -
DEBUG
PORT
DEBUG
PORT
DEBUG
DEBUG
PORT
PORT
DEBUG
DEBUG
PORT
PORT
Pin No. Definition
1
GND
7
2
TXP
7
3
TXN
4
GND
5
RXN
6
RXP
7
GND
Please connect the L-shaped end of
the SATA cable to your SATA hard
drive.
Advertisement
Table of Contents
