Advertisement
In addition
to the following
warnings,
please refer
to manual section on Exhaust Requirements
and
Maintenance.
IMPORTANT."
To reduce the risk of
fire, combustion,
and gas accumulation,
the dryer
must be vented to the outdoors.
Please follow the
instructions
(and all others in this manual)
very
carefully.
• Do not use thin plastic or foil ducting.
• Use 4" (10.2 cm) diameter
rigid or flexible metal
duct (note:
venting materials
are not supplied
with
the dryer, and you should obtain the venting
materials
necessary
for proper installation)
• Position the dryer
where the exhaust duct is
shorter as possible
• Clean old ducts beJbre installing
this dryer
• The male end of each section of exhaust duct must
point away from the dryer
• Use fewer elbow joints as possible
• Use duct tape on all duct joints
• Insulate ductwork
that runs through unheated
areas in order to reduce condensation
and lint
build-up
on pipe walls; and
• PLEASE
BE AWARE THAT FAILURE
TO
EXHAUST
THE DRYER CORRECTLY
WILL
VOID THE DRYER'S
WARRANTY.
WARNING!
• Use a heavy metal vent.
• Do not use a plastic vent.
• Do not use a metal foil vent.
• Failure to follow these instructions
can
result in death or fire.
• Clean old ducts before installing
this dryer
•
ALTERNATE
EXHAUST
DIRECTIONS
] • Remove a screw and exhaust duct.
2- ]. Detach and remove a knockout at the
button, left or right side as desired. (Right
Side Vent not available on Gas dryer)
(1-3, ('_), (5)
the order of work.
i
PORTION
"A"
I
2-2.
f
\
Reconnect the another duct[11 in(28cm)]
to the blower housing, and attach the
duct to the base. (Duct is a SVC part)
3-1.
Pre-assemble
4" elbow with 4" duct.
Wrap duct tape around joint.
DUCT
TAPE
3-2.
Insert elbow duct assembly first through the
side opening and connect the elbow to the
internal duct.
9
Advertisement
