Sony Handycam DCR-HC32E Service Manual page 10

Self-diagnosis Code
Block Detailed
Function Code
E 6 1 0 0
E 6 1 1 0
E 6 1 1 1
E 6 2 0 0
E 6 2 0 1
Note:
Focus reset sensor
Focus motor drive circuit
Zoom reset sensor
Zoom motor drive circuit
NON MS model: DCR-HC17E/HC19E/HC21/HC21E/HC22E
MS model: DCR-HC32/HC32E/HC33/HC33E
DCR-HC17E/HC19E/HC21/HC21E/HC22E/HC32/HC32E/HC33/HC33E
Symptom/State
Difficult to adjust focus
(Cannot initialize focus.)
Zoom operations fault
(Cannot initialize zoom lens.)
Focus lens intializing failure and zoom
lens initializing failure occur
simultaneously.
Steadyshot function does not work well.
(With pitch angular velocity sensor output
stopped.)
Steadyshot function does not work well.
(With yaw angular velocity sensor output
stopped.)
Pin wa of CN3101 on VC-376 board (NON MS model)
Pin wa of CN3701 on VC-377 board (MS model)
IC3101 of VC-376 board (NON MS model)
IC3707 of VC-377 board (MS model)
Pin qh of CN3101 on VC-376 board (NON MS model)
Pin qh of CN3701 on VC-377 board (MS model)
IC3101 of VC-376 board (NON MS model)
IC3707 of VC-377 board (MS model)
Inspect the lens block focus reset sensor (Note) when focusing is
performed when the touch panel is operated in the focus manual
mode and the focus motor drive circuit (Note) when the focusing
is not performed.
Inspect the lens block zoom reset sensor (Note) when zooming is
performed when the zoom switch is operated and the zoom motor
drive circuit (Note) when zooming is not performed.
Inspect the flexible board for breakage or loose connection.
If not faulty, inspect the focus and zoom motor drive circuit (Note).
Inspect pitch angular velocity sensor (SE601 of SI-042 board)
peripheral circuits.
Inspect yaw angular velocity sensor (SE602 of SI-042 board)
peripheral circuits.
1-4E
Correction