Connecting The Water Supply Hose; In Case Of Cold-Hot Washer; Levelling; Water Supply Connector Filter - Samsung WA10K2 User Manual

CONNECTING THE WATER SUPPLY HOSE

1. Remove the adaptor
from the water
supply hose.
2. First,using a "+" type screw
driver, loosen the four screws
on the adaptor.
Next,take the adaptor and
turn part(b) following the arrow for
gap about 5mm between them.
3. Connect adaptor to the
water tap by tightening
the screws firmly.
Then, turn part (b)
following the arrow and
put (a) and (b)together.
4. Connect the water supply hose to
the adaptor. Pull down the part (c)
of the water supply hose .When
the part (c)is released, the hose
is automatically connected to the
adaptor making a 'click' sound.
IN CASE OF COLD-HOT WATER WASHER
•
If you use only cold water inlet hose,
you must fit the cap to the hot water
inlet valve as following.
•
If the washer is not leveled with the ground, it makes the machine tremble more

LEVELLING

or be out of order. So, make sure that the washer is leveled properly.
SEE IF THE MACHINE IS PLACED LEVEL BY CHECKING
THE POSITION OF THE WASHING TUB.
•
Open the lid of the machine, pour water into the tub up to the
level
just below the pulsator, and adjust the legs so that the pulsator is
positioned at the center of the water as
shown in the figure.
•
Place the machine more
than 10cm away from the
wall.
•
Adjust the legs on feet

WATER SUPPLY CONNECTOR FILTER

1.Pull out the filter and wash well.
a
b
a
b
c
2. Pull in the filter and connect
the hose to the inlet water
valve tightly.
5. Connect the other end of the water
5-1.Connect the other end of the water
If the water tap is a screw type,assemble
a water supply hose that fits to the
tap as shown.
NOTICE After completing connection, if water leaks from the hose,
then repeat the same steps.
Use the most conventional type of faucet for water supply.
In case the faucet is square or too big,remove the spacing
ring before inserting the faucet into the adaptor.
cold
Adjustment the heigt of the machine
Adjust the legs to level the washer
Be careful not to put in your hand under the legs.
inlet water
valve
8
supply hose to the inlet water valve
at the back of the washer.
Screw the hose clockwise all the
way in.
supply hose to the inlet water valve
at the top of the washer.
Screw the hose clockwise all the way in.
hot
cap
Pull the handles located at the
right and left of the front side
and slide off.
Adjust the height of the machine
upward or downward.
When the adjustment
is finished, push the handles
to fix the adjusting legs.
3. Check if there is a leakage.
Note to tighten up the
connector.