Table of Contents
Advertisement
Basic Connections/Auto Setup
In this section, you will connect the
Auto Setup, which automatically searches for channels and sets the
player's internal clock.
1
from antenna
1
Connect the RF antenna cable from your indoor/outdoor antenna
or cable
or cable wall outlet to the IN(FROM ANT.) jack on the rear panel
DHR
of the
2
Choose one of the following methods to connect the
2
your TV:
RF Connection:
To TV's
Connect the supplied RF antenna cable from the OUT(TO TV) jack
Antenna Input
on the rear panel of the
Line Connection:
Connect an RCA-type audio/video cable(red, white, yellow) from
the LINE OUT jacks on the rear panel of the
3
Line In jacks.
Use red for right audio, white for left audio, and yellow for video.
It is recommended that you use the Line Connection
if your TV is equipped with RCA jacks.
3
Connect the
wall outlet. Then power is automatically turned on.
• Don't press any buttons on the DHR or remote during auto setup.
"AUTO" blinks while the DHR runs an auto setup procedure, where
it will automatically search for all active channels and set the clock.
• When Auto setting has been completed, the front panel displays
the current time.
• If Auto Clock set is unable to find the current time,
you can set the clock manually;See page 29.
4
Press the STANDBY/ON button on your TV.
5
Set TV to Channel 21~69 or AV.
Be sure to use the same channel you selected.
Auto Setup
Even if you plan to use the S-Video Output, you MUST
Auto CH Search
Audio Options
connect the
Please Wait
Display Options
standard RF or the AV Out connection.
46%
This enables you to operate the
lnstructions
Move
Enter
Return
Exit
Menu
22
DHR
to your television and run
DHR
to
DHR
to your television's Antenna Input.
DHR
to your television's
DHR
power cord to a standard 110~240V /50Hz
DHR
to your television with either the
DHR
setup menu.
DVD/HDD View
The
DHR
uses one set of controls to operate DVD & HDD. The
following buttons are helpful in successfully controlling each one.
1
Press the STANDBY/ON button on the remote control or the front
DHR
panel to turn on the
.
2
Press the DVD button on the remote control or on the front
panel when you want to control the DVD deck.
• The DVD indicator will light on the Front Panel Display to show
that the DVD deck is selected.
3
Press again the HDD button on the remote control or on the
front panel when you want to control the HDD.
• The HDD indicator will light on the Front Panel Display to show
that the HDD is selected.
DVD INITIAL SCREEN
HDD INITIAL SCREEN
LOADING
Basic DVD Playback
Follow these instructions to playback a DVD.
1
Open disc drawer.
• Press the Open/Close button on the remote control or front panel.
2
Insert disc.
• Place the disc in the drawer with the label side of the disc facing
up. If the disc has two sides, orient the disc with the desired label
facing up.
3
Close disc drawer.
• Press the Open/Close button on the remote control or front panel
to close the disc drawer.
4
Press the ❿II(Play/Pause) button on the remote control or front
panel.
• Many discs will begin playback automatically when the disc drawer
closes.
• If the DVD has a disc menu, or more than one title, the disc menu
may appear.
5
Additional DVD options.
• See pages 45~56.
1
3
AV1
2
1
3
4
23
Advertisement
Table of Contents
