1. Manuals
  2. Brands
  3. Kenwood Manuals
  4. Car Receiver
  5. KDC-2031SA/G
  6. Instruction manual

Kenwood KDC-2031SA/G Instruction Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

CD-RECEIVER
KDC-2031SA/G
INSTRUCTION MANUAL
© B64-2937-00/00 (EW/E2W)

Advertisement

Table of Contents
loading

Related Manuals for Kenwood KDC-2031SA/G

Summary of Contents for Kenwood KDC-2031SA/G

  • Page 1 CD-RECEIVER KDC-2031SA/G INSTRUCTION MANUAL © B64-2937-00/00 (EW/E2W)

  • Page 2: Table Of Contents

    Contents Safety precautions Accessories/ Installation Procedure Notes Connecting Wires to Terminals About CDs Installation General features Removing the Unit Power Troubleshooting Guide Selecting the Source Volume Specifications Attenuator System Q Audio Control Audio Setup Speaker Setting Clock Display Adjusting Clock Dimmer Control DSI (Disabled System Indicator) Theft Deterrent Faceplate...

  • Page 3: Safety Precautions

    DC power supply. not operate normally after a while, consult your • Do not install the unit in a spot exposed to direct Kenwood dealer. sunlight or excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing.

  • Page 4: Notes

    Notes • If you experience problems during installation, This Product is not installed by the manufacturer consult your Kenwood dealer. of a vehicle on the production line, nor by the professional importer of a vehicle into an EU • If the unit fails to operate properly, press the Reset Member State.

  • Page 5: About Cds

    About CDs Handling CDs Removing CDs • Don’t touch the recording surface of the CD. When removing CDs from this unit pull them out horizontally. CDs that can’t be used • CDs that aren’t round can’t be used. • CD-R and CD-RW are easier to damage than a normal music CD.

  • Page 6: General Features

    General features Release button Control knob MONO ATT/DIM ATT indicator LOUD indicator Power Volume Turning ON the Power Increasing Volume Press the [SRC] button. Turn the [VOL] knob clockwise. Turning OFF the Power Decreasing Volume Press the [SRC] button for at least 1 second. Turn the [VOL] knob counterclockwise.

  • Page 7: System Q

    System Q Exit Audio Control mode Press any button. You can recall the best sound setting preset for Press the button which is not [VOL] knob and different types of music. [ATT] button. Select the source to set Press the [SRC] button. Select the Sound type Audio Setup Press the [Q] button.

  • Page 8: Speaker Setting

    General features Speaker Setting Exit clock adjustment mode Press the [CLK] button. Fine-tuning so that the System Q value is optimal when setting the speaker type. Enter Standby Press the [SRC] button. Dimmer Control Select the "STBY" display. You can change the unit's display to dimmer. Enter Speaker Setting mode Press the [DIM] button for at least 1 second.

  • Page 9: Tel Mute

    Reattaching the Faceplate Align the projections on the unit with the grooves on the faceplate. Projections Grooves Push the faceplate in until it clicks. The faceplate is locked in place, allowing you to use the unit. TEL Mute The audio system automatically mutes when a call comes in.

  • Page 10: Tuner Features

    Tuner features Control knob MONO 1 – 6 MONO Band display AUTO indicator Frequency display Preset station number ST indicator Tuning Mode Tuning Choose the tuning mode. Selecting the station. Press the control knob. Select tuner source Each time the knob is pressed, the Tuning mode Press the [SRC] button.

  • Page 11: Station Preset Memory

    Station Preset Memory Putting the station in the memory. Select the band Push the Control knob to [FM] or [AM]. Select the frequency to put in the memory Push the Control knob to [4] or [¢]. Put the frequency in the memory Press the desired [1] —...

  • Page 12: Cd Player Features

    CD player features Control knob MONO SCAN RDM REP SCN indicator REP indicator RDM indicator Track number IN indicator Fast Forwarding and Reversing Playing CD Fast Forwarding When a disc is inserted Hold down on [¢] of the Control knob. Press the [SRC] button.

  • Page 13: Track Repeat

    Track Repeat Replaying the song you’re listening to. Press the [REP] button. Each time the button is pressed, the Track Repeat turns ON and OFF. When it's ON, the "REP" indicator is ON. Scan Play Playing the first part of each song on the disc you are listening to and searching for the song you want to listen to.

  • Page 14: Accessories/ Installation Procedure

    Therefore, the speaker wire should be checked. • If your car is not prepared for this special connection- system, consult your Kenwood dealer. • Only use antenna conversion adapters (ISO-JASO) when the antenna cord has an ISO plug.

  • Page 15: Connecting Wires To Terminals

    Connecting Wires to Terminals Rear left output (White) Rear right output (Red) Antenna Conversion Adaptor (ISO– JASO) (Accessory3) REAR Antenna Cord (ISO) Fuse (10A) FM/AM antenna input Wiring harness (Accessory1) Connect to the terminal that TEL mute wire (Brown) is grounded when either the telephone rings or during MUTE conversation.
  • Page 16 Connecting Wires to Terminals 2WARNING Connector Function Guide Pin Numbers for Cable Colour Functions Connecting the ISO Connector ISO Connectors The pin arrangement for the ISO connectors depends External Power on the type of vehicle you drive. Make sure to make the Connector proper connections to prevent damage to the unit.

  • Page 17: Installation

    Installation Installation Metal mounting strap (commercially available) Firewall or metal support Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place. Self-tapping screw (commercially available) Screw (M4X8) (commercially available) • Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (for example, the sound may skip).

  • Page 18: Removing The Unit

    Removing the Unit Removing the hard rubber frame Removing the Unit Engage the catch pins on the removal tool and Refer to the section <Removing the hard rubber remove the two locks on the upper level. frame> (page 18) and then remove the hard Upper the frame and pull it forward as shown in rubber frame.

  • Page 19: Troubleshooting Guide

    Troubleshooting Guide What might seem to be a malfunction in your unit No sound can be heard, or the volume is low. ✔ The fader or balance settings are set all the way to may just be the result of slight misoperation or one side.
  • Page 20 Troubleshooting Guide Disc source The messages shown below display your systems condition. The specified disc does not play, but another one plays instead. E-04: The CD is quite dirty. The CD is upside- ✔ The specified CD is quite dirty. down.

  • Page 21: Specifications

    Specifications Specifications subject to change without notice. FM tuner section Audio section Frequency range (50 kHz space) Maximum output power : 87.5 MHz – 108.0 MHz : 45 W x 4 Usable sensitivity (S/N = 26dB) Output power (DIN 45324, +B=14.4V) : 0.7 µV /75 Ω) : 28 W x 4 Quieting Sensitivity (S/N = 46dB)
  • Page 22 English...
  • Page 23 English...

This manual is also suitable for:

Kdc-2031saKdc-2031sg

Table of Contents