Industry Canada Notices And Other Information - Panasonic KX-TGP550T04 Installation Manual

Industry Canada Notices and other information

NOTICE:
This equipment meets the applicable
Industry Canada Terminal Equipment
Technical Specifications. This is
confirmed by the registration number.
The abbreviation, "IC:", before the
registration number signifies that
registration was performed based on
a Declaration of Conformity indicating
that Industry Canada technical
specifications were met. It does not
imply that Industry Canada approved
the equipment.
Users should ensure, for their own
protection, that the electrical ground
connections of the power utility,
telephone lines and internal metallic
water pipe system, if present, are
connected together. This precaution
may be particularly important in rural
areas.
NOTICE:
Operation is subject to the following
two conditions: (1) this device may
not cause interference, and (2) this
device must accept any interference,
including interference that may cause
undesired operation of the device.
Privacy of communications may not
be ensured when using this
telephone.
Some cordless telephones operate at
frequencies that may cause
interference to nearby TVs and
VCRs. To minimize or prevent such
interference, the base of the cordless
telephone should not be placed near,
or on top of, a TV or VCR. If
interference is experienced, move
10
the cordless telephone further away
from the TV or VCR. This will often
reduce, or eliminate, interference.
RF Exposure Warning:
LThis product complies with IC
radiation exposure limits set forth
for an uncontrolled environment.
LTo comply with IC RF exposure
requirements, the base unit must
be installed and operated 20 cm
(8 inches) or more between
product and all person's body
(excluding extremities of hands,
wrist and feet).
LThis product may not be collocated
or operated in conjunction with any
other antenna or transmitter.
LFor body-worn operation, the
handset must be used only with a
non-metallic accessory. Use of
other accessories may not ensure
compliance with IC RF exposure
requirements.