Setting Up Your Remote Control - Samsung HPN5039 - 50" Plasma TV Owner's Instructions Manual

Changing Channels
Using the Channel Buttons
Press the CH or CH buttons to change channels.
When you press the CH or CH buttons, the PDP changes channels
in sequence. You will see all the channels that the PDP has memorized.
(The PDP must have memorized at least three channels.)
You will not see channels that were either erased or not memorized.
Directly Accessing Channels
Press the number buttons to go directly to a channel. For example, to select
channel 27, press "2" then "7". The TV will change channels when you
press the second number.
When you use the number buttons, you can directly select channels that were
either erased or not memorized. To change to single-digit channels (0~9) faster,
press "0" before the single digit. (For channel "4" press "0", then "4".
Using the Pre-CH button to select the previous channel
Press the PRE-CH button. The TV will switch to the last channel viewed.
To quickly switch between two channels that are far apart, tune to one
channel, then use the number button to select the second channel. Then,
use the PRE-CH button to quickly alternate between them.
Adjusting the Volume
Using the Volume Buttons
Press the VOL + or VOL – buttons to increase or decrease the volume.
Using Mute
Using the MUTE Buttons
At any time, you can temporarily cut off the sound using the MUTE button.
Press the MUTE button and the sound cuts off.
1
The word "Mute" will appear in the lower-left
corner of the screen.
To turn mute off, press the MUTE button again, or
2
simply press the VOL + or VOL – button.
36
Mute

Setting Up Your Remote Control

This PDP's remote control can operate almost any VCR, cable box or DVD. After it has been set up
properly, your remote control can operate in four different modes :TV, VCR, Cable or DVD.
Pressing the corresponding button on the remote control allows you to switch between these modes,
and control whichever piece of equipment you choose.
Note : The remote control may not be compatible with all DVD Players, VCRs, Cable boxes.
The remote control can operate only on STB made by Samsung.
Setting Up the Remote to Operate Your VCR, Cable box or DVD player
Turn off your VCR. (or Cable box, DVD player)
1
Press the MODE button. Mode is changed whenever
2
MODE button is pressed(New mode is displayed on
LED screen).
Press the SET button on your TV's remote control.
3
Using the number buttons on your remote control,
4
enter three digits of the VCR (or Cable box, DVD
player) code listed on page 38 of this manual for
your brand of VCR (or CATV, DVD). Make sure you
enter three digits of the code, even if the first digit
is a "0".
(If more than one code is listed, try the first one.)
Press the Power button on the remote control.
5
Your VCR (or CATV, DVD) should turn on if your
remote is set up correctly. If your VCR (or CATV,
DVD) does not turn on after setup, repeat steps
2, 3, and 4, but try one of the other codes listed for
your brand of VCR (or CATV, DVD).
If no other codes are listed, try each code, 000
through 089 (or Cable box: 000 through 077,
DVD player: 000 through 008).
Notes
• When your remote control is in "VCR" mode, the VCR control buttons (Stop, REW, Play/Pause, FF)
still operate your VCR.
• When your remote control is in "CATV" or "DVD" mode, the VCR control buttons (Stop, REW,
Play/Pause, FF) still operate your VCR.
37