Configuring Mode Config Operation On The Vpn Firewall - NETGEAR FVS318G-100NAS Reference Manual

Note: After configuring a Mode Config record, you must manually configure an IKE
policy and select the newly-created Mode Config record from the Select Mode
Config Record pull-down menu (see
VPN Firewall." You do not need to make changes to any VPN policy.
Note: An IP address that is allocated to a VPN client is released only after the VPN client
has gracefully disconnected or after the SA lifetime for the connection has timed
out.

Configuring Mode Config Operation on the VPN Firewall

You need to configure two screens: the ModeConfig screen and the IKE Policies screen.
Configuring the Mode Config Screen
To configure the Mode Config screen:
1. Select VPN from the main menu and Mode Config from the submenu. The Mode Config
screen displays.
Figure 5-32
2. Click Add. The Add Mode Config Record screen displays (see
Virtual Private Networking
ProSafe Gigabit 8 Port VPN Firewall FVS318G Reference Manual
"Configuring Mode Config Operation on the
v1.1, August 2010
Figure 5-33 on page 5-46).
5-45