Maxtor OneTouch II User Manual page 11

18. If you're ready to install the Retrospect software, click Install.
After the software is installed on your computer, the message
"InstallShield Wizard Completed" will appear.
19. Click the Finish button.
2
If a message appears asking you to restart, follow the
on-screen directions to restart your computer.
The Welcome to Maxtor OneTouch Setup screen will appear
and a Maxtor OneTouch shortcut icon will appear on
your desktop.
20. Please remove the Maxtor Install CD from your computer.
21. Proceed to the next section: Connect the Drive.
9
Step 2. Connect the Drive
The Maxtor OneTouch II drive connects to your computer using
either a FireWire or USB interface. Make sure you know which
interface is available on your drive and on your computer.
Please Install the software BEFORE you connect
the drive.
Connecting the Power
1. Plug the round female connector from the power adapter into
the drive's power connector.
2. Plug the two-pin female connector on the power cord
into the power adapter.
Figure 3. Connecting the Power
3. Plug the standard electrical plug from the power adapter into
your power source.
4. Turn on the Maxtor OneTouch II drive using the power switch
on the back of the drive. The two blue lights on the front should
illuminate.
5. Determine whether you have USB or FireWire ports available
on your computer. If you are connecting your drive with