Advertisement
ENGLISH
This battery pack uses rechargeable lithium ion batteries. You can charge it any time you
wish.
• Please be sure to read this manual thoroughly before use. Also, refer to the manual of
the equipment for which you use this battery pack.
• Before use, please refer to the manual of your digital camera or video camera and make
sure that Battery Pack BP-511 A is compatible with it.
Charge the battery pack before you use it.
Your battery pack was partially charged before it left the factory. It should have enough
power for you to check that your Canon equipment is working properly. However, you must
charge the battery pack fully if you want more than a few minutes of power.
For details, refer to the instructions provided with your charger.
Charging and operating times
• Refer to your product instructions for information on charging and
operating times.
• You will get more usage time if you turn the product off when it is not in operation.
• Charging and operating times vary - the safest policy is always to have two or three times
as many battery packs as you think you will need.
• Operating time will be shorter than usual at low temperatures. You can use the battery
pack between 0' and 40'C (32' to 104'F), but it works best between 10' and 30'C (50' to
86'F).
• If the battery pack starts to give you much less operating time than usual (at normal
temperatures) it has reached the end of its life and must be replaced.
When to recharge
You can recharge a lithium ion battery pack whenever it is convenient. Unlike a conventional
battery pack, it does not have to be fully discharged first. However, as the battery pack will
naturally discharge itself over time, it is best to charge it the same day you plan to use it, or
the day before.
In addition, there is the possibility of damage to the battery pack and reduced usage time if
fully charged batteries are stored for a period of months.
Always attach the terminal cover.
Do not allow any metal objects to touch the terminals (Figure A), as this can cause a short
circuit and damage the battery pack. Attach the terminal cover whenever the battery pack is
not being used (Figure B).
Keep the terminals clean.
The battery pack, charger or the product itself will not work properly if the terminals are dirty.
Check them before use, and wipe them with a dry cloth or tissue if necessary.
Disconnect the battery pack when you are not using it.
Even when it is turned off, the product the battery pack is attached to will continue to slowly
drain power from the battery pack.
When you plan to store a battery pack aim to use its complete charge first. before
disconnecting it. Store the battery pack in an area which is free of moisture, and where the
temperature is no higher than 30'C (86'F).
DANGER!
• Keep the battery pack away from fire (or it might explode).
• Do not expose it to temperatures greater than 60'C (140'F). Do not leave it near
a heater, or inside a car in hot weather, for example.
• Do not try to disassemble or modify it.
• Do not drop or knock it.
• Do not get it wet.
Canon battery packs are designed exclusively for use with other Canon products. Canon is
not responsible for damage or accidents resulting from use with non-Canon brand chargers
or other products.
About the battery terminal cover:
The battery terminal cover has a [oj-shaped hole. This is useful when you wish to
differentiate between charged and uncharged battery packs. For example, with charged
battery packs, attach the terminal cover so that the [oj-shaped hole shows the blue label
(Figure C).
Specifications
BP-511A
Battery type
RecharQeable lithium ion battery
Rated voltaae
7.4 V DC
Operatina temperature
o
to 40'C (32 to 104'F)
Batterv capacity
1390 mAh
Dimensions
38 x 21 x 55 mm (1.5 x 0.8 x 2.2 in)
Weight
82 g (2.9 oz)
• Weight and dimensions are approximate.
• The specifications and appearance of the battery pack are subject to change without
notice.
Advertisement
