Related Manuals for EarthQuake MiniMe P10
Summary of Contents for EarthQuake MiniMe P10
- Page 1 Sound That Will Move You MiniMe P10 & P12 Models User's Manual Earthquake Sound Corporation www.earthquakesound.com...
-
Page 2: Safety Instructions
Safety Instructions 1. Read Instructions — All the safety and operation instructions should be read before the Earthquake Component is operated. 2. Retain Instructions — The safety and operating instructions should be kept for future reference. 3. Heed Warnings — All warnings on the Components in these operating instructions should be followed. -
Page 3: Table Of Contents
WARNING: The MiniMe subwoofers are capable of generating high sound pressure levels. You should exercise caution when operating these speakers. Long term exposures to high levels of sound pressure will cause permanent damage to your hearing. Sound pressure levels exceeding 85dB can be dangerous with constant exposure, set your audio system to a comfortable loudness level. -
Page 4: Introduction
Earthquake Sound Corporation is located in the heart of the Silicon Valley. manufacturing high end Home and Mobile audio products ranging from the smallest driver to the loudest subwoofer systems. -
Page 5: Control Panel Overview
WARNING: SHOCK HAZARD-DO NOT OPEN AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR 220-240V www.earthquakesound.com Earthquake Sound, 2727 McCone Avenue, Hayward, CA 94545 USA (3) Voltage Selection Switch (4) Manual ON/OFF Switch terminals will accept up to 16-gauge quality speaker wire. The Inputs should be connected to the left and right speaker terminals of your amplifier or receiver. - Page 6 (6) Auto ON/OFF When the main “POWER” ON/OFF switch is in the “OFF” position, this switch has no affect on the subwoofer. When the main “POWER ON/OFF” switch is in the “ON” position, this switch allows the auto circuit to be engaged. When this switch is in the “AUTO”...
-
Page 7: Installation
We recommend that you place your woofer further than two feet away from your TV, VCR, DVD player, tape deck or computer, so the speaker's magnet won't distort the color of you TV picture or erase your video tapes, audio tapes, discs...etc. -
Page 8: Connections
• Whenever possible, keep the power cords away from the signal cable or speaker wires to prevent any hum or inference being heard in speakers. • Choose reliable, high quality interconnect cables, also called patch cords or RCA cables. -
Page 9: Location
Location Fact: Subwoofers reproduce frequencies with wavelengths that are long in relation to the dimensions of most living rooms. Standing waves will boost or cancel various frequencies due to the interaction with the room boundaries. Moving a subwoofer in a room will change what you hear in the listening position a lot. -
Page 10: System Configurations
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING: SHOCK HAZARD-DO NOT OPEN AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR 220-240V www.earthquakesound.com Earthquake Sound, 2727 McCone Avenue, Hayward, CA 94545 USA PRE-AMPLIFIER SUB/LFE OUT AMPLIFIER INPUTS TO FRONT SPEAKERS VOLUME... - Page 11 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING: SHOCK HAZARD-DO NOT OPEN AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR 220-240V www.earthquakesound.com Earthquake Sound, 2727 McCone Avenue, Hayward, CA 94545 USA PRE-AMPLIFIER AMPLIFIER INPUTS TO FRONT SPEAKERS VOLUME POWER FREQUENCY...
- Page 12 PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING: SHOCK HAZARD-DO NOT OPEN AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR Earthquake Sound, 2727 McCone Avenue, Hayward, CA 94545 USA FRONT SPEAKERS LEFT RIGHT VOLUME...
-
Page 13: Adjusting The Controls
You will need a test CD with low-frequency warble tones, and a sound pressure-level meter. Step #1 Disconnect the subwoofer and run the main speaker with a tone in its passband (80-100Hz). Measure the level. Step #2 Disconnect the main speaker and reconnect the subwoofer. -
Page 14: Specifications
MiniMe P10 Specifications Amplifier Output 600 Watts (4-Ohm impedance) High Cut Filter 50Hz-160Hz adjustable. The crossover can be bypassed by rotating the crossover frequency control fully clockwise. Frequency Response 20Hz - 135Hz Power Line Voltage 110-220V~AC / 50 - 60Hz / 720 WATTS Dimensions (HxWxD) 12-1/4”... - Page 15 The five (5) year warranty period is valid only if an authorized Earthquake dealer properly installs the product and the warranty registration card is properly filled out and sent to Earthquake Sound Corporation. If a non-authorized party installs the product, a ninety (90) day warranty period will be applied.
- Page 16 Earthquake Sound Corporation 2727 Mc Cone Avenue, Hayward, California 94545 Ph (510) 732-1000 Fax (510) 732-1095 www.earthquakesound.com...