Assemble The Freezer Drawer; Adjusting The Level - Samsung RF323TEDBSR User Manual

3. Take out the lower basket (
basket up from the rail system.
4. Press the fi xing hook of the rail system.
5. Holding the top of the Freezer Drawer, pull it out all
the way, and then remove it from the rail system.
Be careful not to scratch or dent the sliding
rail by letting it strike the fl oor.
CAUTION
Make sure that you mount the freezer
basket in the right position when removing
CAUTION
/ installing the freezer door. Failing to do
so may result in the door not opening or
closing properly.
Putting too much food into the freezer
drawers can prevent the freezer from
CAUTION
closing completely and can cause frost
build-up.
2 ) by lifting the
2

ASSEMBLE THE FREEZER DRAWER

To reattach the drawer after you have moved
the fridge to its fi nal location, assemble the parts
in reverse order.

ADJUSTING THE LEVEL

Make sure the refrigerator is level so that you can
make fi nal adjustments. Use a level to test if the
refrigerator is level both side to side and back to
front. If the refrigerator is not level, it will not be
possible to get the doors perfectly even, which
may cause moisture condensation and increased
energy bills. Below is an example of how to level
the refrigerator if the left side of the refrigerator is
lower than the right side.
How to adjust the level
1. Open the freezer drawer and remove the lower
basket.
2. Insert a fl at-blade screwdriver (-) into a notch
on the left control lever, and turn it counter-
clockwise to level the refrigerator. (You turn the
lever clockwise to lower the refrigerator and
counterclockwise to raise it.)
fl at-blade screwdriver (-) Control Lever fl at-blade screwdriver (-)
CAUTION
Control Lever
Both control levers must be touching the
fl oor to avoid possible personal injury or
property damage because of tipping.
If the right side is lower, perform the same
procedure, but with the right control lever.
It is diffi cult to remove the cover leg
front from the refrigerator, so we do not
recommend making small adjustments
with the control lever. Instead, refer to the
next page for the best way to make minor
adjustments to the doors.
setting up _09