Philips SBA3210/00 User Manual

Philips SBA3210/00 User Manual

Philips soundshooter portable speakers sba3210 twins

Advertisement

Quick Links

Register your product and get support at
www.philips.com/welcome
SBA3210/00

User manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SBA3210/00 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Philips SBA3210/00

  • Page 1: User Manual

    Register your product and get support at www.philips.com/welcome SBA3210/00 User manual...
  • Page 2: Important Safety Instructions

    Important Safety Important Safety Instructions • Heed all warnings. • Follow all instructions. • Do not use this apparatus near water. • Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. • Do not install near any heat sources such as radiators, heat registers, stoves, or other devices (including amplifiers) that produce heat.
  • Page 3: Disposal Of Your Old Product

    Notice Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. This product complies with the radio interference requirements of the European Community. Disposal of your old product Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.
  • Page 4: Get Started

    Get started Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the apparatus. Write the numbers here: Model No.
  • Page 5 To recharge the built-in battery: Connect your speaker with PC through supplied cable. The power indicator turns on.(white) » • The power indicator turns off when it’s fully charged. Play 1 Connect your two speakers with supplied cable. 2 Connect your device to the speaker. 3 Slide the switch to turn the speaker on.
  • Page 6: Product Information

    Product information Note • Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power 2 x 2W RMS Signal to Noise Ratio >70dB Aux-in Link 600 mV RMS, 10 kohm General information DC power input USB: 5V, 500mA Built-in Li-Polymer battery 3.7V 500mAH, each unit Battery working time...
  • Page 7: Troubleshooting

    If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www.philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available. No power: Recharge your speaker.
  • Page 8 All registered and unregistered trademarks are property of their respective owners. © 2012 Koninklijke Philips Electronics N.V. All rights reserved. SBA3210_00_UM_V1.0...

Table of Contents