Fcc Compliance; Industry Canada Compliance - Garmin ANT+ adapter for iPhone Instructions Manual

Table of Contents

Advertisement

FCC Compliance

This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy
and may cause harmful interference to radio communications if not
installed and used in accordance with the instructions. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet that is on a different circuit
from the GPS unit.
Consult the dealer or an experienced radio/TV technician for
help.
This product does not contain any user-serviceable parts. Repairs
should only be made by an authorized service center. Unauthorized
repairs or modifications could result in permanent damage to the
equipment, and void your warranty and your authority to operate this
device under Part 15 regulations.

Industry Canada Compliance

Category I radiocommunication devices comply with Industry
Canada Standard RSS-210. Category II radiocommunication devices
comply with Industry Canada Standard RSS-310. This device
complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired
operation of the device.
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ant+

Table of Contents