Replacing The Lamp - Electrolux ENN2643AOW User Manual

14 www.electrolux.com
Problem
Water flows on the
ground.
The temperature in
the appliance is too
low.
The temperature in
the appliance is too
high.
The temperature in
the refrigerator is too
high.
The temperature in
the freezer is too
high.
Upper or lower
square is shown in
the temperature dis-
play.
DEMO appears on
the Display.

REPLACING THE LAMP

CAUTION!
Disconnect the plug from the mains
socket.
Possible cause
The melting water outlet
does not flow in the evapo-
rative tray above the com-
pressor.
The temperature regulator
is not set correctly.
The temperature regulator
is not set correctly.
Many products are stored
at the same time.
There is no cold air circula-
tion in the appliance.
Products are too near to
each other.
An error has occurred in
measuring the temperature.
The appliance is in demon-
stration mode (DEMO).
Solution
Attach the melting water
outlet to the evaporative
tray.
Set a higher temperature.
Set a lower temperature.
Store less products at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
Store products so that there
is cold air circulation.
Call your service representa-
tive (the cooling system will
continue to keep food prod-
ucts cold, but temperature
adjustment will not be possi-
ble).
Keep pressed approximately
10 sec. the Light button
since a long sound of buzzer
is heard and the Display
shut off for a short while: ap-
pliance start works regular-
ly.