Table of Contents
Advertisement
b. Verify that the "SSID" of your network adapter is set to the same "SSID" of the other
station (or another network adapter).
c. Verify that the "channel" of the network adapter is "Auto" or set to the same
"channel" of the other station (or another network adapter).
d. Verify that the "Encryption" type is the same as the other station (or another
network adapter). If "WEP" encryption is enabled, you must set the same
"WEP" Keys on both stations.
Bad link quality or bad signal strength
There are two possible reasons: radio interference and distance:
•
To avoid radio interference, keep the environment around the network adapter
away from microwave ovens and large metal objects. Then try to reorient the
network adapter antenna.
•
Decrease the distance between your network adapter and the access point or
station (or another network adapter).
The TCP/IP protocol did not bind to the network adapter.
This will occur when the computer already has six TCP/IP bindings in Windows
98 or ten bindings in Windows Me. These limits are imposed by the Microsoft
operating system.
Solution: If your computer already has the maximum number of TCP/IP bindings,
remove one of the network adapters from the network configuration before
installing the network adapter driver.
42
ASUS USB-N10
Chapter 5: Troubleshooting
Advertisement
Table of Contents
