Asus P8B75-M LX PLUS User Manual page 42

7. Intel B75 Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1 [gray])
®
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0
Gb/s signal cables.
P8B75-M LX PLUS
P8B75-M LX PLUS Intel
• You must install Windows. XP Service Pack 3 or later version before using Serial ATA
• When using hot-plug and NCQ, set the SATA Mode Selection item in the BIOS to [AHCI].
8. USB 3.0 connector (20-1 pin USB3_34)
This connector is for additional USB 3.0 ports. Connect the USB 3.0 bracket cable to
this connector, then install the USB 3.0 bracket to the rear side of the chassis. If your
chassis supports front panel ports, you can use the ASUS USB 3.0 header to install
additional front panel USB 3.0 ports.
P8B75-M LX PLUS
P8B75-M LX PLUS USB3.0 Front panel connector
The USB 3.0 module is purchased separately.
1-30
®
hard disk drives.
See section 2.5.3 SATA Configuration for details.
USB3_34
SATA 6.0Gb/s connectors
PIN 1
Chapter 1: Product introduction